Octolapse cant set it up right,i'm stuck - Plugins - OctoPrint Community Forum

Hello guys, I was wondering if someone could help me to setup the octolapse. My printer is an creality cr6se with raspberry pi4b 4gb and a logitech 922. The slicer that i am using is cura 5.1.1 I am spending a few evenings now and i cant setup octolapse the right way. Now i get the error gcode priming was not detected. I watched several tutorials but they use old version of octoprint or plugin. So is there someone who have an cr6se profile that i can load in my octoprint? here is

Cannot install any plugin after fresh octoprint install - Plugins - OctoPrint Community Forum

OctoPrint

New Setup, Layer Shifting Benchy at same position each time - Get Help - OctoPrint Community Forum

Octolapse cant set it up right,i'm stuck - Plugins - OctoPrint Community Forum

V0.4 Getting Started · FormerLurker/Octolapse Wiki · GitHub

OctoPrint

OctoPrint

Octolaps wont start - Octolapse - OctoPrint Community Forum

octolapse not working : r/octoprint