Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

LulzBot Mini Review: Compact, Powerful Yet Easy to Use

Introduction to Low-Cost 3D Printing

3D Printing Troubleshooting Guide

reprap-factoids/scrape.jsons at master · nathan7/reprap-factoids · GitHub

Extruder Struggling - AO-101 & AO-100 - LulzBot

Flash printer - AO-101 & AO-100 - LulzBot

A digital twin ecosystem for additive manufacturing using a real-time development platform

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

I've got like an hour and a bit left of my print. Why did this happen? : r/FixMyPrint

Purchase Advice Megathread: What To Buy, Who To Buy It From, And More, In July 2018. : r/3Dprinting