Output Standard Rated Net COP in OpenStudio different from Input Rated COP in EnergyPlus report - Unmet Hours

I'm setting efficiency (COP) of some DX Cooling Coil Single Speed in the AirLoop Packaged Rooftop Heat Pump equipment for compliance Baseline of ASHRAE 90.1. I'm setting the Rated COP field to the desired efficiency according to the standard. However, when opening the EnergyPlus results, in the report Equipment Summary, the Standard Rated Net COP is different, lower than what I had set the input. This only happens in the DX Cooling Coils, but does not happen in DX Heating Coils, where the outputs are the same as inputs. Could someone help me understand why this difference and how to properly adjust the inputs according to the standard.

Group – Plant Equipment: Input Output Reference — EnergyPlus 8.0

Energy and cost assessment of packaged ice energy storage implementations using OpenStudio Measures - ScienceDirect

Thermal Loads inside Open Studio and Energy Plus Results - honeybee - Ladybug Tools

Energy and cost assessment of packaged ice energy storage implementations using OpenStudio Measures - ScienceDirect

CBECC Com UserManual, PDF, Hvac

2018 Book BuildingEnergyModelingWithOpen PDF, PDF, Proprietary Software

The Radiant Whole Life Carbon Study by Introba - Issuu

Energy Modeling Training: Introduction to OpenStudio/E+ - PDF Free Download

Hourly simulation data - Unmet Hours

Energy Modeling Training: Introduction to OpenStudio/E+ - PDF Free Download

Energy and cost assessment of packaged ice energy storage implementations using OpenStudio Measures - ScienceDirect

Applied Sciences, Free Full-Text