Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Cura not retracting correctly - UltiMaker Cura - UltiMaker

New Cura feature! Maximum volumetric flow rate setting! : r/3Dprinting

Travel settings

Cura for Bambu X1 and P1 Series by AmaZz0r

Dual Extrusion settings explanation - UltiMaker Cura - UltiMaker

Coasting not applied on parts with only outer walls - UltiMaker

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Extra gcode in the files from Cura. - UltiMaker Cura - UltiMaker

Dual Extrusion settings explanation - UltiMaker Cura - UltiMaker

Cura for Bambu X1 and P1 Series by AmaZz0r